Connecting to DC Power
DC power is cabled using the AC/DC power adaptor (supplied) which is connected to a standard AC electrical wall outlet. Typically, the DC power source is used for power redundancy with the AC power source (see note below).
| ● | DC power support is a separate orderable item. |
| ● | When both power supplies are used (AC and DC), the device is powered from the AC power source only. The DC source starts feeding the device only upon an AC power outage. |
DC Power Specifications
|
Physical Specification |
Value |
|---|---|
|
Input Voltage |
12VDC / 10A |
Use only the AC/DC power adaptor that is provided by AudioCodes when ordering DC power.
| ➢ | To connect the device for DC power: |
| 1. | Insert the male DC plug into the DC inlet connector located on the device's rear panel. When inserting the DC plug, make sure that the latch faces up (see following figure). Make sure that the latch snaps into the inlet, indicating that the terminal block has been firmly plugged in. |
Connecting DC Power Plug to DC Inlet
| 2. | Plug the female connector that is located on one end of the AC power cord (supplied), into the AC/DC power adaptor. |
Plugging AC Power Cord into AC/DC Adaptor
| 3. | Plug the other end of the AC power cord (supplied) into a standard electrical wall outlet. The device's DC PWR LED, located on the front panel, lights up green. |